VIKING Invisible Zipper Foot (Group 1-8)

PART # 920458096
HUSQVARNA® VIKING® Invisible Zipper Foot (Group 1-8) 

Always fasten the concealed zipper before the seam is sewn. The underside of the foot has two grooves where the toothing of the zipper runs during sewing. The concealed zipper must always be at least 3 cm longer than the slit.

Other information

1. Mark the length of the zipper opening on the seam allowance and on the zipper. The excess length should be at the bottom of the zipper.
2. Snap on the Invisible Zipper Foot. Select center needle position straight stitch. Length 2.5 - 3.0.
3. Unzip the zipper.
4. Place the right part of the zipper on the fabric's right sides together. The coil should be on the seamline and the top stop of the zipper 3/4" (2 cm) below the cut edge of the fabric. (Illustration A)
5. Fingerpress up the zipper coils and lower the presser foot with the zipper coils in the right opening under the foot. (Illustration B)
6. Adjust needle position to align the needle with the needle guide on the front of the foot. Backstitch and sew. Stop at the mark on the zipper and seam allowance and backstitch to tie off. (Illustration C)
7. Place the left part of the zipper right side together with the left side of the garment. Lower the presser foot with the left opening over the zipper teeth. Make sure that the needle is perfectly aligned with the needle guide in front of the foot again. Sew in the same way as the first side.
8. Pull up the zipper pull. Place the fabric with the zipper's right sides together. Snap-on the regular Zipper Foot to the left of the needle. Adjust needle position to the right. Start stitching in the backstitched seam and sew the seam below the zipper. (Illustration D
If the zipper is too long, whipstitch across the zipper teeth 1 1/4" (3 cm) below the inserted zipper length. Cutaway excess zipper below the whipstitching.