How to use:

1.  Select a straight stitch, snap on the Rolled Hem Foot, and engage the IDT™ system (if available on your machine). If needed, press only the beginning of the hem to 2, 3, or 4mm wide, depending on your foot size. Place it flat in the groove under the foot and sew, pulling the fabric's cut edge into the hemmer's scroll. Lower the presser foot and continue sewing while holding for a few stitches. Lower the needle into the fabric to hold it in place. Then, raise the presser foot, keeping the cut edge up in front of the foot.
2.  Do not allow the fabric to run under the right half of the presser foot.

WORKS WITH MACHINE

• B
• C
• D
• E
• F
• G
• J
• K